Glass Bottle Spraying Process

Here is Customized Beverage Bottles Suppliers talking about Glass bottle spraying process. 

If you have any idea about Oem Beverage Bottles, welcome to contact us and discuss.

The spraying production line of glass bottles generally consists of a spray booth, a hanging chain, and an oven. Glass bottles are also treated with water treatment. The special attention of glass bottles is the problem of sewage discharge. As for the quality of the glass bottle, it is related to the water treatment, the surface cleaning of the workpiece, the electrical conductivity of the hook, the amount of gas, the amount of dust spray, and the level of the operator. It is recommended to try the following methods:

1. Pre-processing segment

The pre-discharging section of the glass bottle includes pre-off, main off, surface adjustment, etc. If it is in the north, the temperature of the main off part should not be too low and heat preservation is required. Otherwise, the processing efficiency is not ideal;

2. Preheating section

After pre-treatment, it is necessary to enter the preheating section, which usually takes 8~10 minutes. When the glass bottle reaches the powder spraying chamber, it is necessary to make the workpiece have a certain amount of residual heat to increase the adhesion of the powder;

At the same time, Glass Juice Bottles For Canning can be offered for you.  Looking forward to receiving your inquiry.